No Name

General Craft Discussion => Full range of crafts covered here => Card Making => Topic started by: chris w on September 15, 2007, 09:36:22 AM

Title: if you run out of 3d pads
Post by: chris w on September 15, 2007, 09:36:22 AM

get a small piece of tissue and put onto it some pva glue and roll it into a little ball and use that, it works well in an emegency when you run out of sticky pads

Title: Re: if you run out of 3d pads
Post by: nuttycluster on September 15, 2007, 11:34:29 AM

That's a good tip Chris.
A suppose as it becomes obvious that you're going to run out you could ration the foam pads just to the outer edge and hide the fake ones in the middle.


Nuttycluster